SUNWARD SWL 2021 Series, Руководство оператора

Страница: 67 / 91

SWL2820 Operator’s Manual
66
5.5.1
B
EFORE STARTING
5.5.1.1 CHECKING ENGINE OIL LEVEL

Cool down the oil if the engine was running before. In this case wait 15 minutes for
cooling down the oil before carry out the check.

For checking the oil level, raise the dipstick (see photo below) and read the oil marks on
it. The oil sign should be between the Min. and
Max. limit written on the dipstick.

If the oil mark is lower than the minimum limit,
refill engine oil as soon as possible. Refill the
engine oil through the inlet shown in the right
figure.
5.5.1.2 CHECKING ENGINE COOLANT LEVEL

Cool down the coolant if the engine was running
before. In this case wait 15 minutes for cooling
down the coolant before carry out the check.

The coolant level in the coolant tank should be
between the two limit marks.

If necessary, add coolant through the coolant cap
(shown in the right figure).

Do not remove the coolant cap when the fluid is
hot, since it could spray out violently and cause
injury.
5.5.1.3 CHECKING ENGINE FUEL LEVEL

For checking the engine fuel level use the
indicator located in the instrument panel. The
indicator should comes on when turning the
ignition key to position “ON”.

If the fuel level is low, refuel before starting
engine.
5.5.1.4 CHECKING THE HYDRAULIC OIL LEVEL

Check the oil level through the gauge located in
the backside of the hydraulic tank. The oil level
has to be between the two limit marks on the
gauge. Refill with the suitable oil if necessary.

When refill hydraulic oil, do not exceed the Maximum limit.

The level must be checked with the machine in a level surface and the oil cooled down.

Check the hydraulic circuit when an abnormal decrease of the oil level is observed.

Before check the level in the gauge, release the pressure inside the hydraulic tank by
loosing the filling cap.

Before check the level in the gauge, release the pressure inside the circuit by lowering
slowly the hydraulic cylinders.