SUNWARD SWE215F-5, Руководство по эксплуатации и техническому обслуживанию

Страница: 157 / 182

OPERATION & MAINTENANCE MANUAL SWE215F
150

Reinstall plug screw of oil fill port 1 and inspection
port 2.

Check the gear oil level on another side of travel
redactor with the same method.
4.5.6.3 Checking, Adjusting Belt Tension of A/C Compressor
Inspection
The deflection should be 5 to 8mm, when pressing at a
point midway between drive belt pulley and compressor
belt pulley with a finger pressure of 58.8N(6kgf).
Adjustment

Loosen bolts (1) .
Fasten the adjust screw (2) with hands to make the
deflection of the belt to 5-8mm (about 58.8N (6 kgf)).

Fasten the bolt (1).

Check the belt pulley for damage, whether the V shape
slot and V shape belt wear out. If the belt is drew out,
there's no adjustable capacity or there’s notch and crack
on it, it's time to replace with a new one.

While adjusting the belt, reset it again after one hour’s
operation.
4.5.6.4 Cleaning Air Filter Element

Stop the machine at level ground, lower bucket to
ground.

Shut auto-idle speed switch to run engine unloaded at
low speed for 5 minutes.
【
Important
】

Stopping the engine improperly may damage
turbocharger.

Set start key to OFF position, stop the engine, remove
the key from starting lock, set pilot safety lever to
LOCK position.

Loosen clamp buckle (2) to remove air filter front
cover.

Remove outside filter (1), clap slightly by hand, never
hit with hard object.
Note

Minimize pressure of compressed air (<0.2
(2)
(1)
Air filter