SUNWARD SWE215F-5, Руководство по эксплуатации и техническому обслуживанию, Страница: 150 / 182

OPERATION & MAINTENANCE MANUAL SWE215F
143
2kgf/cm2), scatter personnel around to avoid
scattered metal particles, wear personal
protective articles including goggles and
protective glassed.

Use compressed air to clean outside filter (1),
following the wrinkle direction to blow air outward.

Clean up the inside filter.

Install outside filter (1), end cover, fasten clamp
buckle (2).

Start engine; run it unloaded at low speed. Check filter
clogging indicator on monitor. If this indicator
illuminates, shut engine immediately and replace
outside filter (1).

Replace internal filter (3) the moment outside filter (1)
is replaced.
4.5.3.2 Cleaning Cooler
After the machine works a certain period of time, the cooler
surface will be covered with dust or other foreign material
which will influence radiating effect of cooler. It should be
cleaned in time.

Open left inspection door( left back door)
；

Loosen the mounting bots located on left side of
condenser, open up condenser of A/C.

Use compressed air (below 0.2 MPa) or water to rinse
condenser.

Remove the strainer (if present) in front of radiator for
cleaning up.

Use compressed air (below 0.2 MPa) or water to rinse
cooler.

Reinstall the front strainer (if provided) and condenser
of A/C.
Note: Do not remove air conditioning pipes,
failure to do so will cause coolant leakage and air
conditioner malfunction.