SunTech ADC ADview 9000BP, Руководство пользователя, Страница: 38 / 80

27
2. Briefly (less than 2 seconds) press the temperature mode select button until it
displays
for axillary.
3. After a few seconds, the device will beep to signify that the probe is ready for
placement. After the beep, lift the patient’s upper arm and place the probe high
under the patient’s axilla. Apply pressure gently to assure good contact between the
probe and axilla, and make sure there is no interference such as clothing. Hold the
probe in place so that its tip maintains tissue contact. Place the arm by the patient’s
side. During measurement, a “traveling dash”
is displayed.
Note that proper placement of the probe is essential to the accuracy of the
measurement.
4. After 10-15 seconds, a long beep signals the end of the measurement cycle. The
temperature will display for two minutes or until you initiate a new measurement.
5. Remove the probe, discard the probe cover and place back in the probe holder. Note
the temperature reading.
Taking a Rectal Temperature Taking a Rectal Temperature Taking a Rectal Temperature Taking a Rectal Temperature
1. Remove the blue probe and well by sliding the pieces upward until
they detach.
2. Place the red probe in the holder of the red well and the probe
connector in the notched space as shown to the right (see page 38
for detailed instructions). Slide the red well vertically onto the
back of the module thus replacing the blue well.
3. Assist patient into a prone (facedown) position and ensure
that the patient is relaxed.
4. Remove the red probe from its holder and secure a disposable cover on it. The probe
pre-heating process begins with the flashing display of
.
5. After a few seconds, the device will beep to signify that the probe is ready for
placement. After the beep, separate the patient’s buttocks and apply a thin coat of
water-based lubricant for smooth entry of the probe. Insert the probe gently 1 cm
inside the sphincter. Tilt the probe to keep it in place and hold it in position to
ensure tissue contact. During measurement, a “traveling dash”
is displayed.
Notched space/Probe connector