18
Sunstone Welders
User Manual
:
CDDP-A
▪ Alarm: Electrode Stuck
▪ Alarm: Weld Counter Preset Limit
▪ Alarm: Invalid Remote Schedule Selection
▪ Alarm: Wrong trigger detected
▪ Alarm: Trigger in No Weld State
▪ Alarm: Part Check Failed
▪ Warning: Temperature
▪ Warning: Comparator Failures in a Row
▪ Warning: Weld Counter Preset Limit
▪ Weld Ready
▪ Alarm
• An ESTOP is available for safety. It is normally open and engaged. It must be closed to
disengage the E-STOP. Pin out information can be found on
p. 9
.
• Ethernet (Coming Soon)
▪ This is available for those who would like to control the welder, with a PLC, through Ethernet.
Maintenance
• Internal verifications can be performed, but can only be accessed through a technical support
screen.
• This can be performed anytime the welder seems to be creating weak welds.
• User will want to perform this Internal verification at least once a year to ensure that their
welder is performing optimally.
• Certificate of Calibration
• This is a service that Sunstone Engineering can perform. Contact Sunstone Support if
desired.
Safety
Safety Precautions for Mechanical Moving Parts
•
Refer to the user manual included with your weld head or hand piece.
•
Before pressing foot pedal and triggering weld, make sure nothing is obstructing the
electrodes, other than the workpiece being welded.
•
If maintenance or setup is required put the welder in a “Weld Off” state, or turn unit off before
adjusting weld head.
