62
If there is a fault, the “Work State” will show
“Fault”. Tap the “Fault” cell.
The state column of the module that has fault will
display “Fault. As shown in the left figure, a fault
occurs to module unit 2. Tap the fault cell of
module unit 2 to check the present fault.
The fault interface of module unit 2 will appear
with the fault item in red.
9.11 Starting/Stopping
Usually, the MV Station will start automatically when the grid-connected
requirements are met.
Start/stop the MV Station through the LCD screen in either of the following manners:
•
Tap “Start/Stop” from the default menu.
•
Tap “Start/Stop” from the Function menu.
By tapping the start/stop button on the screen, all the MV Station will start or stop at the
same time. A confirm operation interface will appear after tapping the corresponding
buttons. The instruction takes effect after confirmation; or the user can cancel the
operation by tapping “Cancel”.
9.12 Load Default
Proceed as follows to restore factory defaults:
step 1
Tap “Function” from the default menu.
step 2
Tap “Set-parameter”.
step 3
Tap “Sys-parameter” after entering the correct password.
System Manual
Содержание SG4950HV-MV
Страница 2: ......
