***
In this configuration the heater
turns off
when all three pumps are
running in high speed.
Note: pump #2 and pump #3 run only in high
speed.
7.0 Start-Up Instructions
FOR BEST RESULTS, READ EACH STEP IN ITS ENTIRETY BEFORE
PROCEEDING WITH THAT STEP.
A. Prepare The Hot Tub For Filling
• Clear all debris from the hot tub. (Although the hot tub shell has been
polished at the factory, you may want to treat it with a specially for-
mulated hot tub cleaner. Consult your dealer for additional informa-
tion prior to filling spa.
• Remove filter lid (Figure-F, page 16), then remove filter cartridge from
filter bucket as illustrated in section 11.1 (page 32-33).
B. Fill Hot Tub
• Place the end of your garden hose into the empty filter bucket.
NOTE:
Never fill with water from a water softener. If your water is
extremely “hard”, it is preferable to fill half-way with hard water and the
rest of the way with softened water. Or, you may fill entirely with hard
water if you use a special water additive available from your Sundance
dealer.
• Fill hot tub until water level is midway in filter bucket skimmer opening
and above all jets.
Do not overfill.
Important:
Always fill your hot tub through the filter bucket after
draining. Failure to do so may cause air to be trapped in either pump,
preventing the pump from circulating water.
•
Remove the hose and replace the filter cartridge as illustrated in section
11.1 (page 32-33).
Page 13
