Page 30
At any time, you may check the programming of any aspect of any
skimming/heating cycle by first pressing
CYCLE
then moving through the
menu by pressing either
CYCLE
or
SELECT.
The programming is changed
only by pressing
UP
or
DOWN
during this process.
10.3 Programming The Change Filter Reminder
Your new spa is equipped with a programmable “Change
Filter” reminder that appears on the control panel display after
a specified number of days. It is designed to remind you to
clean and/or replace your filter cartridge(s) on a regular basis but does not
affect spa operation in any way. This reminder must be reset at each filter
cleaning interval. It offers a selectable range from 10-120 days or can be
disabled. We recommend an initial setting of 30 days, after which you can
easily determine whether you need to shorten or lengthen its interval by
visually inspecting your filter cartridge. Refer to section 11.1 (page 32-33)
for filter cleaning recommendations.
Programming Instructions
(1) Press the
CYCLE
sensor seven times. The main display reads “FIL”
indicating the “Change Filter” display program has been accessed.
(2) Press
SELECT
sensor once to display currently programmed duration or
days elapsed since last filter cleaning interval.
(3) Press
UP
or
DOWN
sensor to change duration as follows:
0 - 10 - 20 - 30 - 40 - 50 - 60 - 70 - 80 - 90 - 100 - 110 - 120 - OFF
(4) Press
DISPLAY
sensor once to save changes and return to the
standard water temperature display.
Note: If no sensor is pressed
within 30 seconds, the screen will automatically return to the standard
water temperature display.
10.4 Programming Circulation Pump Run Time
The Sentry control system allows you to easily adjust two separate aspects
of circulation pump operation:
1. The time of day (start time) the circulation pump turns on.
2. The length of time (duration) the circulation pump operates.
The factory default start time is 12:00AM (Midnight). The default duration
is 24 hours. To make adjustments, press the sensor labeled
CYCLE
five
times to enter the circulation pump programming mode. The LCD screen
will display
ADJUST Circ.
At this time the system is ready to accept your
changes.
CHANGE
FILTER
