Description of all Functions
Start the wash without a time delay
VERY IMPORTANT: The dishwasher door must be open for all operations for
selecting the start of the wash.
A program is selected by pressing the corresponding key. The program selected will
be indicated by the corresponding pilot LED, and in the case of the Lux range, will
be shown in the display: “P1”, “P2”, “P3”, ... In these Lux models, two seconds after
the last time the Programs Key is pressed, the duration of the program will be shown
in the display. (For example, if P3 has been selected, after 2 seconds the display will
change from “P3” to “1H” / “30” alternating, i.e., the display will show: for 2 seconds
On, then for 0.5 sec. “1H”, then for 0.5 sec. “30”, then for 2 sec. “P3”, then for 0.5
sec. “1H”, then for 0.5 sec. “30”,…).
To see which program has been chosen, press the program key once, at any time.
The door is then shut, and, after approximately 2 seconds, a beep indicates the start
of the program. (If the water temperature is greater than 45º, the beep will not sound
till after 3.5 seconds).
The pilot LED for the program chosen will be on during the whole program until it ends
( when that LED will go out and the “End” LED will come on) or there is a change to
another program. In the case of the Lux range, the end of the program will be shown
on the display, by displaying “00” seconds.
Interrupting the wash
Every time the door is opened, the wash program is interrupted, the time countdown
is stopped, and all jets are turned off. To restart the wash, just close the door.
While the door is open, the current program’s pilot LED will stay on, and in the case
of the LUX models, the display will show,
fl
ashing (0.5 sec. ON, 0.5 sec. OFF) “PH”
(to indicate a Pause).
VERY IMPORTANT: If the door is opened during a stage when the water is being
warmed (whether it is washing or paused), the resumption of the wash will take 3.5
minutes (Safety time, according to the Safeties Table), and that is not part of the wash
time countdown.
Changing the wash program
If the program is changed or the option of Half Load Upper/Lower is changed when it
has already started, the program does not restart from the beginning. This means that
the same program step is maintained, or if the same step does not exist in the new
program, it will go to the closest following step that both programs have in common,
