Sunbeam 0282, Руководство пользователя

Страница: 4 / 28

- 4 -
1. Diode for the cooling indicator light
2. Cooling-ON LED indicator light
3. Resistor for the cooling indicator light
4. Cold water cooling power switch
5. Refrigeration thermostat for the cold water
6. PTC starter for the compressor
7. Refrigeration Compressor
8. Thermal protector for the refrigeration compressor
9. Diode for the heating indicator light
10. Heating-ON LED indicator light
11. Resistor for the heating indicator light
12. Heating power switch
13. Thermostat for the hot water
14. Heater
15. Thermostat for the hot tank temperature limit
16. Diode for the power indicator light
1 7 . Po w e r- O N LED indicator light
1 8 . Resistor for the power indicator lights
ELECTRICAL DIAGRAM
P R E PARING YOUR WATER DISPENSER FOR USE
No. 0282
PLACE
BOTTLE
VERTICALLY
STRAIGHT
DOWN
1) Make sure that the water dispenser is not plugged into the electrical outlet.
2) Before placing water bottle on unit, be sure that the drain plug on the back is tightly fastened.
3) Hold the water bottle vertically and upside down (over water dispenser) and place the water bottle into the no-
spill bottle receptacle. Apply slight pressure in order to pierce the bottle cap with the spigot. This unit accepts two,
three or five gallon water bottles with pierceable sealed caps.
4 ) Open the taps to let the air out, until the water starts to flow. When this happens, release the taps.
Don’t plug the unit in until water comes out of the water taps.
5) Plug the water dispenser into a grounded power outlet and turn the power switches on.
6) If the water dispenser is brought in from outside in the winter time, give it a few hours to warm up to room
temperature before plugging it in. The thermostat setting may be affected by the coldness of the water dispenser
itself or the bottled water.
7) You should have hot water in approxmately 15 minutes and cold water in less than 1 hour.
• The refrigeration thermostat is factory set between 7ºC and 8ºC (44.6ºF and 46.4ºF).
• The hot water thermostat is factory set between 87ºC and 88ºC (188.6ºF and 190.4ºF).
• The hot and cold indicator lights will be on while the system is working. Once the desired
temperatures have been reached, the lights will go off.
• Before the water dispenser leaves the factory, the thermostat is set properly.
NOTE: When your water dispenser is in operation there is a small amount of water in the passage
between the water tanks and the taps. This water is not controlled by the cold, hot or room
temperature settings. We recommend that in order to fully enjoy the desired temperature
setting, you should eliminate this small amount, 200ml - 400ml (6.76 fl.oz - 13.52 fl.oz) using
a small glass container.