Sun Oracle X3-2, Руководство по установке

Страница: 62 / 182

50 Sun Server X3-2 Installation Guide • April 2014
7. To disconnect connector A, perform the following steps:
a. Place your left arm under the CMA to support it and grasp the rear end of
connector A with your left hand.
b. Use your right thumb to pull the connector A release lever to the right away
from the left slide-rail (callout 1), and use your left hand to pull the
connector out of the slide-rail [frames 1 and 2].
FIGURE:
Disconnecting Connector A
8. Remove the CMA from the rack and place it on a flat surface.
9. Go to the front of the server and push it back into the rack.
Related Information
“Install the Second-Generation Cable Management Arm” on page 35
▼
Install the First-Generation Cable
Management Arm
Use this procedure to install the cable management arm (CMA), which you can use
to route the server cables in the rack.
Figure Legend
1 Connector A release lever