Sun Microsystems Ultra 40 M2, Руководство по установке операционной системы

Страница: 21 / 50

Chapter 1 Operating System Setup and Installation 11
This script does not execute if the X server is running.
■
If the script exits and you receive an error message, go to Step 6 .
■
If the script executes correctly, go to Step 7 .
6. If the script exits and you receive an error message, perform the following steps to
disable the X server:
a. Type the following at the system prompt:
b. Log in as superuser.
c. Repeat Step 4 and Step 5 .
7. Eject the CD after the driver installation is complete.
8. Reboot the workstation.
9. To enable SLI support, follow the instructions in “Configuring SLI Support” on
page 29 .
Installing Solaris Operating System Drivers
To install the drivers and mount the diagnostic partition when running the Solaris 10
Operating System (if the Solaris Operating System is not preinstalled):
1. Log in to the Sun Ultra 40 M2 Workstation as superuser.
2. Insert the Sun Ultra 40 M2 Workstation Tools and Drivers CD into the DVD drive.
The CD is automounted by the Solaris 10 Operating System.
3. Change to the
/cdrom/cdrom0/drivers/sx86
directory by typing the following
command:
4. Run the install script by typing the following command:
The video drivers are now installed and the diagnostic partition is now mounted.
The script prompts the user to reboot the system for changes to take effect.
% init 3
# cd /cdrom/cdrom0/drivers/sx86
# ./install.sh