Sun Microsystems StorEdge 6920 System, Руководство по началу работы

Страница: 95 / 144

Appendix A Remote Response Service 77
Connecting Multiple Systems
If multiple Sun StorEdge 6920 systems are installed at your site, you can connect the
systems in a chain to share a single telephone line. A maximum of eight systems can
be connected together to communicate with the Sun Service Center.
Note – It is important that you connect the Storage Service Processor to the Storage
Service Processor LAN before configuring the system.
Connecting multiple systems to share a telephone line requires the following:
■
The first system containing the modem must be installed and configured with a
system ID of 0.
■
The telephone line must be connected to the service panel of the first base cabinet.
Note –
There can only be one
new_sp
(the default system name) on the Storage
Service Processor LAN at any one time. Therefore, you must connect the Storage
Service Processor LAN ports, run setup, and give the system a unique system ID for
each system in the chain before connecting the next system.
Before you begin this procedure, contact your local Sun Service Center to request
Sun StorEdge Remote Response installation service.
To connect a Sun StorEdge 6920 system to another system:
1. Connect the SP LAN OUT port on the service panel of the base cabinet to the SP
LAN IN port of the adjacent system.
2. Run setup as described in “Running the Initial Configuration Script” on
page 3-38.
Be sure to give each system in the chain a unique system ID.
3. Contact your local Sun Service Center and ask for Sun StorEdge Remote Response
service activation.
4. If you want to connect another system, repeat the previous steps until each system
in the chain is connected.
For information about connecting the Sun StorEdge 6920 system to a Sun StorEdge
6320 system, contact the Sun Service Center.