Sun Microsystems StorEdge 6920 System, Руководство по началу работы

Страница: 32 / 144

14 Sun StorEdge 6920 System Getting Started Guide • May 2004
Caution –
Never lift the system base cabinet by the cosmetic panel surfaces or pull
it from the back. Instead, push the middle section of the cabinet to prevent it from
tipping over. Use two or more people to move the cabinet safely: one in front to
control the movement and one behind.
3. Secure the base cabinet in position.
To minimize personnel injury in the event of a seismic occurrence, you should
securely fasten the cabinet to a rigid structure extending from the floor to the ceiling
or to the walls of the room in which you place the cabinet.
Install the cabinet on a level surface. There are adjustable nonskid pads at each
corner of the cabinet base. Extend these pads when the cabinet is installed to prevent
the unit from rolling. Do not use these pads to level the cabinet.
4. Ensure the base cabinet has proper ventilation.
Air cools the cabinet from front to back. Air enters at the front, circulates through the
system, and is expelled at both the top and back of the cabinet. Position the cabinet
so as to ensure proper ventilation.
Caution –
Do not block or cover the openings of the cabinet, and do not place it
near a radiator or heat register.
Stabilizing the Base Cabinet
To stabilize the base cabinet, you must perform one of the following procedures:
■
Adjust the leveling pads and install the stabilizer legs
■
Install the floor-mounting brackets
Adjusting the Leveling Pads and Installing the Stabilizer Legs
Unless you are using the floor mounting brackets, the four leveling pads must be
lowered to the floor for the cabinet to meet Underwriters Laboratories’ physical
stability requirements.
The stabilizer legs help prevent the system from tipping over when field-replaceable
units (FRUs) are serviced in the system. The stabilizer legs must be properly
installed and set to be effective.
If you want to attach the system directly to the floor, skip to “Installing the Floor-
Mounting Brackets” on page 17.