Sun Microsystems StorEdge 6920 System, Руководство по началу работы

Страница: 48 / 144

30 Sun StorEdge 6920 System Getting Started Guide • May 2004
Note –
If remote monitoring via the Sun StorEdge Remote Response service is not
possible, configure RAS Telemetry for this system. The type of telemetry sent
includes information such as firmware levels, WWNs, serial numbers, event logs,
and system uptime. Customer data is not sent. The telemetry gathered will allow
Sun to know if your system requires implementation of a field information notice
(FIN), field change order (FCO), or firmware upgrade. To set up encrypted email for
RAS Telemetry, refer to the instructions in “Setting Site Information for Diagnostics
and Monitoring” on page 54 to configure the NSCC Remote Provider Service.
All of the hardware and software required to use the remote response service is
included with the system. To set up the service at your site, you must:
■
Connect a dedicated analog telephone line with dial-out and dial-in capability.
Plug the dedicated telephone line into the PHONE jack on the service panel of the
system cabinet.
■
Set up an SSRR notification provider as described in “Setting Site Information for
Diagnostics and Monitoring” on page 54.
■
Gather the information you need to activate the service using the worksheet in
Appendix A as a guide.
■
Contact your local Sun Service Center and ask for Sun StorEdge Remote Response
installation activation.
The modem installed in the system cabinet is qualified for use in most countries (see
Appendix A for a list of countries) with no modification required.
If you want to connect multiple Sun StorEdge 6920 systems to share a single
telephone line, you must complete the installation and initial configuration of the
first system. You can then connect additional Sun StorEdge 6920 systems, as
described in “Connecting Multiple Systems” on page 77. If you want to connect the
Sun StorEdge 6920 system to a Sun StorEdge 6320 system, contact the Sun Service
Center.
Connecting Data Hosts
The method you use to connect data hosts depends on how you plan to use the
system. The Sun StorEdge 6920 system supports both storage area network (SAN)
and direct attached storage (DAS) configurations for host-side server connections.