Sun Microsystems StorageTek 5320, Руководство по началу работы

Страница: 91 / 226

Chapter 3 Connecting the Sun StorageTek 5320 NAS Appliance 71
Note – To avoid waiting for DHCP discovery, during the boot sequence when the
LCD panel displays “DHCP Discovery NIC X”, you can press any key on the LCD
panel and confirm the “Abort DHCP?” message by pressing the ENTER button on
the panel.
2. Press the ENTER button once, and then select A. Network Config.
3. Select A to set Gateway, if needed.
4. Select B to set the port-emc1 that corresponds to NIC port NET0.
5. Enter the following values in the order listed:
■
IP address
■
Subnet mask
■
Broadcast address
To enter data, use the up and down arrow buttons to change digits and press the
ENTER button to confirm each digit. The cursor moves to the next digit. Once the
last digit is set, press the ENTER button again to proceed to the next network
setting. After the broadcast address is set, press the ENTER button to return to the
Network Config menu.
Accessing the Web Administrator
Note – Before you can access Web Administrator, you must have connected the Sun
StorageTek 5320 NAS Appliance to your network, provided an IP address, and
prepared a client browser on the same network as the Sun StorageTek 5320 NAS
Appliance.
▼
To Connect to the Web Administrator
When you connect to the Web Administrator for the first time, the Configuration
Wizard launches automatically.
1. From a client on the same network, open a web browser and type the IP address
of the Sun StorageTek 5320 NAS Appliance in the address or location field, for
example:
http://123.111.78.99
Press Enter.