Sun Microsystems Netra t1 100, Руководство пользователя и администратора

Страница: 82 / 154

60 Netra t1 User and Administration Guide • June 2000
Powering Up and Configuring for the
First Time
To perform the initial configuration of the Netra t1 system, set up a serial connection
via the port labeled Serial A/LOM on the Netra t1 (see Chapter 6).
Make sure you have the Netra t1’s power cord or cords connected (see Chapter 6).
Configuring via a Terminal Server
To access the Netra t1 system from a Sun workstation via a Terminal Server, open a
Terminal Session on the Sun workstation, and type:
For example, for a Netra t1 system connected to port 10000 on a Terminal Server
whose IP address is 192.20.30.10, you would type:
Configuring from a Terminal or Workstation
To access the Netra t1 system from a dumb terminal just set up a connection between
the terminal and the Netra t1 system.
To access the Netra t1 system from a Sun workstation directly connected to the
system, set up the connections between the devices and run a terminal session. Note,
however, that before you can connect to the Netra t1 system’s Serial A/LOM port
from a Sun workstation, you must edit the
hardwire:
line in your /
etc/remote
file. By default, this line looks as follows:
# telnet <
IP address of Terminal Server
> <
port number
>
# telnet 192.20.30.10 10000
hardwire:\:dv=/dev/term/b:br#9600:el=^C^S^Q^U^D:ie=%$:oe=^D
SysAdmin.book Page 60 Friday, March 30, 2001 2:38 PM