Sun Microsystems Netra t1 100, Руководство пользователя и администратора

Страница: 50 / 154

28 Netra t1 User and Administration Guide • June 2000
Note – If you are going to install a PCI card, install the CD-ROM drive first. If you
have a PCI card already installed, you will need to remove it before installing the
CD-ROM drive (see Appendix B).
1. Remove the top cover by following the procedure described in “Opening the
Netra t1 System” on page 23.
2. Remove the front bezel by pressing the latch at each end (see
FIGURE 4-6
).
3. Remove any PCI card installed in the system (see Appendix B).
4. Squeeze and pull out the blanking panel.
5. Slide the connector card into the slot behind the CD-ROM drive bay (see
FIGURE 4-6
).
6. Connect the cable to the slot under the PCI card (see
FIGURE 4-6
).
7. Slide the CD-ROM drive into its bay until the catch clicks (see
FIGURE 4-6
).
8. Re-install the PCI card (if necessary) as described in “To Install the Card” on
page 121 (in Appendix B).
9. Replace the system cover and screws.
10. Replace the front bezel.
!
SysAdmin.book Page 28 Friday, March 30, 2001 2:38 PM