Sun Microsystems Netra t1 100, Руководство пользователя и администратора

Страница: 126 / 154

104 Netra t1 User and Administration Guide • June 2000
3. Unplug the serial and SCSI cables from the rear I/O board.
4. Using a Phillips No.1 screwdriver, remove the screws and washers from the base
memory board (see
FIGURE A-3
and
FIGURE A-4
).
FIGURE A-3
Removing the Mounting Screws from the Currently Installed Memory Board
5. Position the new spacers over the screw holes (see
FIGURE A-4
).
6. Insert the new, longer screws with their washers through the holes in the new
board (see
FIGURE A-4
).
Place the spring washer on the screws first, and then the plain washer.
7. Position the second memory board above the base memory board so that the
connectors line up and the screws pass through the spacers (see
FIGURE A-4
).
8. Engage the screws in their threads to ensure the board is in the correct position.
Memory Board
Remove short screws
SysAdmin.book Page 104 Friday, March 30, 2001 2:38 PM