Sun Microsystems Enterprise 3500, Руководство по установке

Страница: 24 / 53

Figure 2–2 Key Switch Standby Position
3. Turn the AC power switch to Off.
This switch is at the rear of the system, on the peripheral power supply/AC
(PPS/AC) that is installed in the far left corner (Figure 2–3).
4. Connect the female end of the power cord into the AC connector.
This connector is at the rear of the system, on the PPS/AC, just below the AC
power switch (Figure 2–3).
5. Route the power cord through the power cord retainer clip.
In Step 6 on page 10 of “Installing the Fiber Cable Organizer ” on page 9, you
reattached the plastic clip to the cable organizer that you mounted on the rear
support bracket (Figure 2–3).
a. Use a Phillips screwdriver to open the plastic retainer clip.
Remove the screw.
b. Place the power cord inside the open retainer clip and replace the screw to
close the clip.
12
Sun Enterprise 3500 System Installation Guide
♦
Revision A, April 1998