Sun Microsystems Enterprise 3500, Руководство по установке

Страница: 22 / 53

2. Orient one of the fiber cable organizer sections with the spool facing toward
you. Set the hooks on the back of the organizer into the corresponding cutouts
on the right side of the support bracket.
The top of the brace should be flush with the top of the support bracket. The
organizer will extend below the bracket. See Figure 2–1.
3. Secure the organizer by pushing it outward along the support bracket until the
snap at the rear of the organizer clicks audibly into place.
4. Install the left spool brace by repeating step 2 and step 3.
5. Using the screw included in the kit, fasten the spool braces to the support
bracket through the center front cut out formed when both braces are in place.
6. Remount the retainer clip through the hex nut at the notch on the side of the
organizer.
Set the retainer clip screw into the hex nut.
7. To wrap the 2-meter fiber cable around the organizer spools to interconnect the
interface board and the I/O+ board for FC-AL disks, see “Wrapping the Fiber
Cable on the Organizer” on page 22.
10
Sun Enterprise 3500 System Installation Guide
♦
Revision A, April 1998