Sumitomo HC-4E1, Техническое руководство

Страница: 49 / 64

TROUBLESHOOTING
45
Automatic Shutdown
The compressor will not start or will shut down automatically if any of the following are open:
•
the compressor shell high-temperature switch;
•
the water, oil or gas high-temperature switch;
•
the motor over-current relay;
•
the circuit breaker.
If the compressor has been shut down by one of these interlocks, do not restart until the
problem has been found and corrected. Refer to the Troubleshooting Guide to identify the
problem.
If the unit shuts down again, refer to the Troubleshooting section to determine the cause and
corrective action.
When the shutdown is caused by one of the high-temperature switches, the compressor will
restart only after it has cooled enough for the switch to close. After waiting for the compressor
to cool, press the power switch to restart. Should the compressor fail to start, turn it off and
allow more cooling time. Repeat the start procedure. Check the cooling water temperature and
flow. Compare with Specifications.
The motor over-current relay automatically resets after the compressor shuts down and the
relay cools. To restart the compressor, press the power switch to the on position. If the
compressor fails to start, turn it off and allow more cooling time. Repeat the start procedure.
If the circuit breaker opens, reset the breaker by pushing its lever to the up position.
If a fuse is open, disconnect the power from the compressor, replace the fuse, then restart
the compressor. The two fuses located in the front panel are in the cold head valve motor
circuit.
Refer
to the
Troubleshooting Guide
and the
following procedures for checking
the
compressor’s
electrical components.
The Troubleshooting Guide that follows lists problems that can occur in the compressor and
suggests causes and corrective actions.
AVOID ELECTRIC SHOCK. Disconnect the power to the compressor before
troubleshooting the electrical components.
AVOID ELECTRIC SHOCK. Permit only qualified electrical technicians to open
electrical enclosures, to perform electrical checks or to perform tests with the
power supply connected and wiring exposed. Failure to observe this warning
can result in serious injury or death.