Sumec PowerG PG720BS, Инструкция по эксплуатации

Страница: 12 / 20

Warning! Before you carry out any work on the belt sander
always pull the plug out of the mains socket.
a) Release the tensioning lever 7 for the sanding belt by moving the
tensioning lever 7 fully outwards. The tensioning lever 7 is now open
and the sanding belt can be removed.
b) Insert a new sanding belt or change the belt for one suitable for a
different material or one with a different grit size.
Note: The direction of the arrows on the inside of the sanding belt must
agree with that on sander housing.
b) Press the tensioning lever 7 back into its initial position.
Adjusting the sanding belt
a) Pick up the device, switch it on and turn it over. Adjust the belt
tracking by turning the adjuster screw 5 until the edge of the sanding belt
is flush with and runs parallel to the edge of the device.
Note: Always make sure that the sanding belt does not cut into the
housing.
Check the sanding belt regularly and if necessary re-adjust it using the
adjuster screw.
Fitting dust bag 8
Connect the dust bag 8 to the
dust extraction spout 4 until
it is firmly fitted. (Pic. C)
Warning ! Danger of fire!
There is the danger of fire when working with electrical
devices that have a dust box or can be connected to a vacuum cleaner.
Under certain conditions the wood dust in the dust extraction bag (or in
the dust bag) may ignite, e.g. as a result of flying sparks generated when
abrading metals or metal objects left in wood. This can happen
particularly if the wood dust is mixed with paint residue or other
C
12