![background image](http://html1.mh-extra.com/html/sumec/0533201847zb/0533201847zb_service-manual_1390552005.webp)
5
BOM& Spare Parts List
See Appendix 1.
Operating Instructions
ASSEMBLY
IMPORTANT! THIS SNOWBLOWER IS SHIPPED WITHOUT OIL OR
GASOLINE IN THE ENGINE.
Your new snowblower has been assembled at the factory with the exception of
those parts left disassembled tor shipping purposes. All parts such as nuts,
washers, bolts, etc., necessary to complete the assembly have been placed in
the parts bag. To ensure safe and proper operation of your snowblower, all
parts and hardware you assemble must be tightened securely. Use the correct
tools as necessary to ensure proper tightness.
TO REMOVE SNOWBLOWER FROM CARTON
1. Remove loose parts included with snowblower.
2. Cut down two end corners of carton and lay end panel down flat.
3. Remove all packing materials except padding between upper and lower
handle and padding holding operator presence control bar to upper handle.
4. Roll snowblower out of carton and check carton thoroughly tor additional
loose parts.
ASSEMBLING THE UPPER HANDLE
1. Position the ends of the upper handle on the inside of the lower handle and
align the holes.
2. Insert the arc head bolt into the aligned holes, with the bolt heads on the
inside of the handle.
3. Install the handle knobs on the bolts (Fig. 1) and tighten the knobs securely.
4. Install and adjust the control cable (see Adjusting the Control Cable on
pg.6).
IMPORTANT: Ensure that the cable is routed on the innerside of the handle.
INSTALLING THE RECOIL STARTER HANDLE
Install the recoil starter handle in the rope guide as shown in Fig. 2.