![background image](http://html1.mh-extra.com/html/sumec/0533201847zb/0533201847zb_service-manual_1390552014.webp)
14
checking, tilt the snowblower onto its left side (opposite the oil filler neck).
NOTE: Before placing the snowblower on its side, fully drain the fuel tank using
a gas suction pump. Do not tilt the snowblower by more than 90 degrees.
MAINTENANCE OF THE SPARK PLUG (FIG. 21)
1. Once the engine has cooled, pull off the spark cover with a twist.
2. Remove the spark plug using a spark plug wrench (not supplied).
3. Clean the spark plug with a wire brush (not supplied).
4. Using a feeler gauge, set the gap to 0.7~0.8mm.
5. Install the spark plug carefully by hand, to
avoid cross-threading.
6. After the spark plug is seated, tighten with the spark plug wrench to
compress the washer.
ADJUSTING THE CONTROL CABLE
Refer to Adjusting the Control Cable in assembly. See Adjusting the Control
Cable on page 6.
INSPECTING THE AUGER PADDLE
Service Interval: Yearly - Inspect the auger paddle and have the distributor or
local agent replace the auger paddle and scraper if necessary.
Inspect the auger paddle for wear. When a rotor blade edge has worn down to
the wear indicator hole, have the distributor or local agent replace the auger
paddle and the scraper (Fig. 22).
WARNING:
If the wear indicator hole is intact, you don 't need to replace the
auger paddle. If the wear indicator hole is exposed, replace the auger paddle
and scraper.