Sullivan-Palatek 125G, Руководство по эксплуатации и каталог запасных частей

Страница: 21 / 66

SULLIVAN-PALATEK______________________________
21
6. Once the parameter has been selected, press “enter,” then use the “up” (+) or
“down” (-) keys to change the setting.
7. Press “enter” to effect this change in setting.
8. Press “enter” again and then use the “up” (+) or “down” (-) key to select the next
setting to be changed.
9. Press “enter” and then use the “up” (+) or “down” (-) keys to change the setting.
10. Press “enter” to effect this change in setting.
Once the desired settings have been made, press the “C” key twice (or hold
“reset” for 2 seconds) to return to main menu.
5.4 NORMAL OPERATION
1. Open and lock out main power disconnect.
2. Check lubricoolant level. Refill if necessary.
3. Re-close disconnect switch. Micro processor will illuminate indicating
compressor is ready to start.
4. Start machine by pressing ‘run’ button on micro processor.
5. Fully open service air valve.
6. Observe pressure and temperature. If temperature is incorrect, refer to
SECTION 6.6 – TROUBLE SHOOTING.
5.5 SHUTDOWN
To stop compressor, close service valve, allow sump pressure to fall to 40-45 PSI, then
press stop button on micro processor control.
5.6 STARTS
After a power failure, open and lock out the main disconnect, check all fuses and
breakers. Close disconnect switch and follow Normal Operation start-up procedure.
Following a shutdown caused by either of the protective devices (i.e. temperature or
R.O.P.), open and lock out the main disconnect switch, correct the cause of shutdown,
reset electrical controls, then close the disconnect and follow Normal Operation start-up
procedure.
1. If the overload relay has tripped the motor off, first open and lock out the main power
disconnect, then push the starter overload reset button. Next, check overload relay
to be sure that it is properly sized and correctly adjusted. Note: Never adjust
overload relay higher than indicated by starter manufacturer to match motor
nameplate amperage rating, as an unsafe operating condition will result!
2. Check lubricoolant level. Refill if necessary.
3. Re-close disconnect switch.
4. Start machine by pressing ‘run’ button on micro processor.
5. Fully open service air valve.
6. Observe pressure and temperature displayed by micro processor.