Sullivan-Palatek 125G, Руководство по эксплуатации и каталог запасных частей

Страница: 20 / 66

______________________________SULLIVAN-PALATEK
20
SECTION 5 - OPERATION
5.1 INTRODUCTION
Read this entire Operator’s Manual to familiarize yourself with the SULLIVAN-PALATEK
Plant Air Compressor, giving special attention to the Section 1 - SAFETY.
5.2 INITIAL START
Open main disconnect to be sure there is no power to the compressor.
Review all the steps covered in Section 4 - INSTALLATION to be certain all instructions
have been complied with.
Inspect for any visible signs of damage that could have occurred during installation.
Check lubricoolant level. Check if oil-fill cap is tight.
Close main disconnect. The micro processor display will illuminate and indicate line
pressure and discharge temperature.
Follow procedure in 4.6 to establish correct rotation.
WARNING: Reverse rotation will cause damage that is not covered by warranty.
Rotation must be checked whenever the compressor has been moved to a new
location, or after any change or reconnection of the main electrical wiring.
After closing and latching the starter cover door, close the main disconnect and start the
compressor by pushing green ‘run’ button.
With the service air valve closed, allow machine to pump up to normal operating
pressures and observe operation of automatic controls, and look for any possible leaks.
Open service air valve and check operation throughout the range of pressures,
observing operating temperatures.
Push red ‘stop’ button and check lubricoolant level after it has been allowed to settle for
a few minutes. If it is necessary to add lubricoolant, be sure to open main power
disconnect, lock it out, and be sure to relieve all oil separation tank pressure prior to
removing fill cap to top off tank.
If unloaded pressure is incorrect, readjust regulator and control pressure settings as
required.
5.3 MICRO PROCESSOR PROGRAMMING; GENERAL INSTRUCTIONS
The operational menus which normally have to be addressed are P01 (operations), P02
(fault history), and P04 (maintenance setting). Access codes which are required to
change settings are:
0009 for operational settings (P01)
0100 for faults and service (P02 & P04)
To get the access code, use the following procedure:
1. Simultaneously press the “up” (+) and “down” (-) keys.
2. Press “enter” to advance digits.
3. Use “up” (+) or “down (-) keys to select the correct numeral.
4. When the appropriate access code is shown, press “enter.”
5. After the access code has been selected, use the “up” (+) or “down” (-) keys to
change the corresponding parameter menu (i.e. P01, P02, or P04).