Rev.06
– 03/02/2021
Pag. 21/33
Code: 71207
Connect the battery charging connector to the battery charger;
Proceed with the recharge as per the battery charger instruction manual.
IMPORTANT NOTE!
It should also be remembered that when the cut off device intervenes, the SCOOTER
inevitably stops working.
This event must in no way be a source of danger for the diver, who will have planned the
diving activity, taking into account that the use of the SCOOTER cannot be considered
as a system to safeguard one's life or to remove oneself from difficult situations.
SUEX s.r.l. declines all responsibility following the intervention of the cut off system, in
any situation, in dangerous situations or in dives for which the diver has (at his complete
risk) entrusted his return to the surface to the SCOOTER.
The SCOOTER must be considered as an aid to diving and not as a means of rescue.
21.5. MAIN SWITCH
The main switch, already described earlier in this manual (see chapter "SCOOTER CONTROLS"), plays a main role,
from the point of view of safety, as it separates the battery from the electronic engine control. The switch in the OFF
position prevents the possibility of accidental activation of the SCOOTER.
21.6. MECHANICAL CLUTCH ON THE PROPELLER
See Chapter "Prop lock propeller".
21.7. TRIGGER GUARD
The trigger is imprisoned by a guard that forces the diver to insert a finger in the handle to press the trigger and start
the SCOOTER: in this way the start can only occur after a voluntary action from the user.
22.
RUNNING TIME AND SPEED
Running time data is indicative and is nevertheless referred to use:
with a SCOOTER in perfect running order;
in moderate environments;
in the absence of currents;
with an average load (diver with a double tank 12+12 liters or oxygen rebreather);
in perfect buoyancy conditions.
As a rule the running time must be calculated, an autonomy RESERVE must also be established which will vary
according to the type of dive.
In any case, the dive must be programmed taking into account that it can return to the point of emersion without the
aid of the SCOOTER.
As with autonomy, speed also depends on the same factors. The speed compatible with the type of dive must be
considered and adjusted to that of the companions.
23.
BLUETOOTH CONNECTION
SUEX SCOOTERs are equipped with bluetooth devices that allow to get motor and battery information (if Li-ion
battery with Drive system has been installed).
These functions are available only out of water and require the Calypso App (available on Google Play & App store).
In order to turn the Bluetooth system on, the battery has to be connected to the motor and the SCOOTER has to be
switched ON.
In order to read the battery data when the battery is off-board, connect the battery to the charger and plug the charger
to the main. Once the Bluetooth devices are ON, the application is ready and the data can be read.
First time connection will require Bluetooth pairing of devices and smartphone.
The battery with DRIVe system will have an identifier of this type: SB_AAxxxxxxxxxxxx_BT.
The motor has a serial number such as AAxxxxxxxxxx.
From here on, follow the App instructions.
SCOOTER acceleration ramp can be adjusted by the same App.
