Rev.06
– 03/02/2021
Pag. 14/33
Code: 71207
12.
SCOOTER CONTROLS
12.1. SWITCH
The main switch (6 - fig.1) cuts off the battery power supply to the motor.
The use of the switch prevents accidental operation of the SCOOTER.
12.2. REVOLVING HANDLE
Fig.4
In the control device (fig. 4) we find: the trigger (43D), a handle (43B) a fixing knob (43A), and a relative knob locking
screw, an accessory fixing knob (43C), two seats for accessories (46).
The handle has four positions: two for use (right or left) and two for lifting (top or bottom).
As for the use, the handle can be positioned on the right as in the photo (fig.4) or on the left.
To move the handle: unscrew the knob (43A) without extracting it, rotate the handle, repositioning it on the opposite
side and screw the knob back on.
To make lifting the SCOOTER easier, the handle can be positioned up or down, unscrewing the knob (43A) without
removing it, rotate the handle to the desired position and screw the knob back on.
The seat (46) is useful if optional accessories are used.
13.
SCOOTER DIVING SETTINGS
The attitude of the SCOOTER must be NEUTRAL and in an almost horizontal position. This means that it must
remain at the desired depth without sinking or floating and in a horizontal position.
The SCOOTER is supplied with neutral trim in fresh water.
By adding the sea ballast (23 - fig. 7) supplied, it can be adapted for use in salt water.
13.1. INSERTING THE BALLAST
To insert the ballast (23) proceed as follows: (fig. 4).
Open the SCOOTER (see instructions in the paragraph "Opening the battery compartment"), unscrew the threaded
knobs (22) and insert the ballast (23) in the dedicated hole located between the two threaded knobs. Screw the
threaded knobs (22) back on.