Subaru Legacy 2020, Руководство пользователя

Страница: 89 / 244

11.
Select (Download Now) to begin
downloading the update (if available).
●
Cancel (Cancel): Select to stop the update process.
●
The download status progress is displayed in the
category area.
●
If the update procedure fails, refer to the
“TROUBLESHOOTING” section. (
→
P.238)
*
1
: 11.6-inch display with Navi system
*
2
: 11.6-inch display system with SUBARU STARLINK Safety and Security
*
3
: 11.6-inch display system without SUBARU STARLINK Safety and Security
UPDATE INSTALLATION
CAUTION
l
Park your vehicle in a safe place when installing the update.
l
The following system functions are restricted during the update
installation.
• It will not be possible to use general system functions.
• Only the rear view camera image will be displayed. Or the
image will disappear temporarily.
1.
Download any available updates.
2.
Select (Install Now) to start installing the
update.
●
Installation will take several minutes.
NOTE
l
During software update installation, the screen may flicker. However,
this is not a malfunction.
3.
When installation is complete, select OK (OK) on the
confirmation message to complete the update process.
●
If the update procedure fails, refer to the
“TROUBLESHOOTING” section. (
→
P.238)
4.
Turn the ignition switch to the “LOCK”/“OFF” position
→
Open the driver’s side door
→
Close the door
→
Wait for 3
minutes or more
→
Start the engine.
●
The new software will be applied.
OTHER SETTINGS
89
Settings
3
GB8_US.indb 89 2020/10/09 7:22:37