Subaru CROSSTREK HYBRID 2016, Руководство пользователя

Страница: 143 / 546

Instruments and controls/Meters and gauges
The display can be switched as shown in
the following sequence by pressing the
trip knob.
*1: They cannot be displayed when the
ignition switch is in the
“
ON
”
position.
*2: Displayed only for models with BSD/
RCTA.
To change the current setting, press and
hold the knob for at least 2 seconds.
: Activated
: Deactivated
NOTE
.
Your vehicle
’
s initial movement
setting of the meter/gauge needles
has been set for activation
“ ”
at
the time of shipment from the factory.
.
It is not possible to change the initial
movement setting of the meter/gauge
needles when the ignition switch is in
the
“
ON
”
position. Change the setting
when the ignition switch is in the
“
OFF
”
or
“
ACC
”
position.
&
Meter/Gauge needle illumi-
nation setting
It is possible to activate or deactivate the
illumination of the meter needles and
gauge needles.
When the setting is activated or deacti-
vated, the meter needles and gauge
needles illuminate and turn off as follows.
Activated:
The needles will illuminate and turn off
after approximately 20 seconds when the
driver
’
s door is opened while the ignition
switch is in the
“
OFF
”
position.
The illumination of the needles gradually
turns off after the ignition switch is turned
from the
“
ON
”
position to the
“
OFF
”
position.
Deactivated:
The needles will not illuminate when the
driver
’
s door is opened while the ignition
switch is in the
“
OFF
”
position.
The illumination of the needles turns off
immediately after the ignition switch is
turned from the
“
ON
”
position to the
“
OFF
”
position.
NOTE
.
Even during the illumination after
the driver
’
s door is opened, if the
ignition switch is turned to the
“
ON
”
position, the combination meter will
illuminate as usual.
.
If the doors are locked by the remote
keyless entry system or keyless ac-
cess function during the illumination
after the driver
’
s door is opened, the
illumination will be turned off.
.
Even while the illumination gradu-
ally turns off after the ignition switch is
turned to the
“
OFF
”
position, if the
ignition switch is turned to the
“
ON
”
position, the combination meter illumi-
nate as usual.
3-6