Subaru CROSSTREK HYBRID 2016, Руководство пользователя

Страница: 141 / 546

Instruments and controls/Push
–
button ignition switch
Power
status
Indicator color Operation
OFF Turned off
Power is turned
off.
ACC Orange
The following
systems can be
used:
audio and ac-
cessory power
outlet.
ON
Orange
(while hybrid
system is
stopped)
All electrical
systems can be
used.
Turned off
(while hybrid
system is run-
ning)
CAUTION
.
When the push-button ignition
switch is left in
“
ON
”
or
“
ACC
”
for a long time, it may result in 12
V auxiliary battery discharge.
.
Do not spill drinks or other
liquids on the push-button igni-
tion switch. It may cause a mal-
function.
.
Do not touch the push-button
ignition switch with a hand soiled
with oil or other contaminants. It
may cause a malfunction.
.
If the push-button ignition switch
does not operate smoothly, stop
t h e
o p e r a t i o n . C o n t a c t a
SUBARU dealer immediately.
.
If the push-button ignition switch
does not illuminate even when
the instrument panel illumination
is turned on, have the vehicle
inspected at a SUBARU dealer.
.
If the vehicle was left in the hot
sun for a long time, the surface of
the push-button ignition switch
may get hot. Be careful not to
burn yourself.
NOTE
.
The push-button ignition switch can-
not be switched to
“
OFF
”
when the
select lever is in a position other than
“
P
”
.
.
When operating the push-button
ignition switch, firmly press it all the
way.
.
If the push-button ignition switch is
pressed quickly, the power may not
turn on or off.
.
If the indicator light on the push-
button ignition switch flashes in green
when the push-button ignition switch is
pressed, steering is locked. When this
occurs, press the push-button ignition
switch while turning the steering wheel
left and right.
!
Battery drainage prevention func-
tion
When the push-button ignition switch is
left in the
“
ACC
”
or
“
ON
”
position for
approximately 1 hour, the push-button
ignition switch will be automatically
switched to
“
OFF
”
to prevent the battery
from going dead. This function is activated
when the select lever is in the
“
P
”
position.
&
When access key does not
operate properly
Refer to
“
Access key
–
if access key does
not operate properly
” F
9-23.
3-4