Subaru 2014 Forester, Руководство пользователя

Страница: 362 / 546

system.
&
Remote transmitter program
(models without
“
keyless ac-
cess with push-button start
system
”
)
New transmitters can be programmed to
the remote engine start system in the
event that a transmitter is lost, stolen,
damaged or additional transmitters are
desired (the system will accept up to eight
transmitters). New remote engine start
transmitters can be programmed accord-
ing to the following procedure.
1. Open the driver
’
s door (the driver
’
s
door must remain opened throughout the
entire process).
2. Depress and hold the brake pedal.
3. Turn the ignition switch to
“
ON
”
then
“
LOCK
”
, back to
“
ON
”
then
“
LOCK
”
, back
to
“
ON
”
then
“
LOCK
”
, then back to
“
ON
”
again and leave the ignition
“
ON
”
through-
out the programming process.
4. The system will flash the side marker
lights, tail lights and parking lights and
honk the horn three times, indicating that
the system has entered the transmitter
learn mode.
5. Press and release the
“ ”
button on
the transmitter that you want to program.
6. The system will flash the side marker
lights, tail lights and parking lights and
honk the horn one time, indicating that the
system has learned the transmitter. Upon
successful programming, the remote start
confirmation transmitter button will flash
one time.
7. Repeat step 5 for any additional
transmitters (the system will accept up to
eight transmitters).
8. The system will exit the transmitter
learn mode if the key is turned to the
“
LOCK
”
position, the door is closed or
after 2 minutes.
&
System maintenance
NOTE
For models without
“
keyless access
with push-button start system
”
:
In the event that the vehicle
’
s battery is
replaced, discharged or disconnected,
it will be necessary to start the vehicle
a minimum of one time using the key
prior to activating the remote engine
start system. This is required to allow
the vehicle electronic systems to re-
synchronize.
!
Changing the battery
CAUTION
.
Do not let dust, oil or water get on
or in the remote engine start
transmitter when replacing the
battery.
.
Be careful not to damage the
printed circuit board in the re-
mote engine start transmitter
when replacing the battery.
.
Be careful not to allow children to
touch the battery and any re-
moved parts; children could
swallow them.
.
There is a danger of explosion if
an incorrect replacement battery
is used. Replace only with the
same or equivalent type of bat-
tery.
.
Batteries should not be exposed
to excessive heat such as sun-
shine, fire or the like.
For models with
“
keyless access with
push-button start system
”
:
Perform the procedure described in
“
Re-
placing access key battery
” F
11-45.
Starting and operating/Remote engine start system (dealer option)
7-19
–
CONTINUED
–