Subaru 2013 Forester, Руководство пользователя

Страница: 442 / 529

Black plate (448,1)
一 般
Model "A8190GE-C" EDITED: 2013/ 3/ 29
11-16
Maintenance and service/Engine oil
2. Pull out the level gauge, wipe it clean,
and insert it again.
3. Be sure the level gauge is correctly
inserted until it stops.
1) Full level
2) Low level
3) Approximately 1.0 liter (1.1 US qt, 0.9
Imp qt) from low level to full level
4. Pull out the oil level gauge again.
5. Check the oil levels on both sides of
the level gauge. The engine oil level must
be judged by the lowest of the two levels.
If the oil level is below the low level mark,
add oil so that the full level is reached.
CAUTION
Be careful not to touch the engine
oil filter when removing the oil filler
cap. Doing so may result in a burn, a
pinched finger, or may cause some
other injury.
To add engine oil, remove the engine oil
filler cap and slowly pour engine oil
through the filler neck. After pouring oil
into the engine, you must use the level
gauge to confirm that the oil level is
correct.
NOTE
To prevent overfilling the engine oil, do
not add any additional oil above the full
level when the engine is cold.
!
Diesel engine models
NOTE
For diesel engine models, make sure to
check the engine oil level 5 minutes
after the engine stops. Waiting any
longer will prevent accurate oil level
measurement.
1. Park the vehicle on a level surface.
2. Keep the engine idling until the idle
speed stabilizes. When starting the engine
from the completely cold state, continue
warming up the engine until it reaches the
normal operating temperature range, as
notified by the turning off of the coolant
temperature low indicator light that has
illuminated in blue on the combination
meter. After that, stop the engine and wait
for 5 minutes.
1) Engine oil level gauge
2) Engine oil filler cap
A) ENGINE OIL
B) SEE OWNER
’
S MANUAL