Sub-Zero Wolf CE Series, Руководство по обслуживанию

Страница: 22 / 31

Page 22
Cooktop Electric (CE) Series
Cooktop Electric (CE) Series Troubleshooting
4-4
#826496 - Revision A.1 - April, 2017
Element Temperature Test
Touch “+” pad during the Heat Sink Temperature Test. 1.
Five “.” displayed on left rear control zone. •
2-digit display shows 00, but is not active on CE models. •
“-” pad returns to Heat Sink Temperature Test and “+” pad advances to Error Code Indicator. 2.
Note:
Element Temperature: Built-in Thermal Limiter
Each element has a built-in thermal limiter to protect the glass top. •
Thermal limiter opens between 1040° F and 1076° F. •
Thermal limiter closes at approximately 950° F. •
Error Code Indicator
Touch “+” pad during the Element Temperature test. 1.
Six “.” are displayed on left rear control zone. •
Front control zone shows 0-8 dimmed “.” based on how many error codes are logged. •
Fully lit LED indicates which error is being displayed in the 2-digit display. •
If only a single error has been logged, only a single fully lit LED is displayed. •
If no errors are logged SIM/MLT , HI , and “.” are not displayed and “- -” is displayed in the 2-digit display. •
2-digit display shows the corresponding error code stored in memory. •
Front left SIM/MLT and HI are dimmed. •
Touch the front control zone
SIM/MLT or HI pads cycles through the stored error codes. 2.
Touch and hold TIMER pad for 5 seconds to clear error code history. 3.
Clearing the error code history is only possible if at least one error was logged. •
Clearing the error code history is confirmed by a double beep. •
If an error is currently present when the log is cleared, it immediately regenerates an error code. •
“-” pad returns to Element Temperature test and “+” pad advances to Showroom Mode menu. 4.
Showroom Mode
Touch “+” pad during the Error Code Indicator. 1.
Seven “.” displayed on left rear control zone. •
Touch the left front control zone
HI pad to engage showroom mode. 2.
SH is displayed in the 2-digit display when in showroom mode. •
Touch the left front control zone SIM/MLT pad to disengage showroom mode. 3.
”-” pad returns to Error Code indicator and “+” pad advances to Software Version indicator. •
Software Version Indicator
Touch “+” pad during Showroom Mode. 1.
Eight “.” are displayed on left rear control zone. •
2-digit display cycles to show the software version of the control. •
“-” pad engages the Showroom Mode menu. 2.
1
2
3
4
5
Figure 4-1. Element Assembly Locations