Page 16
Cooktop Electric (CE) Series
Cooktop Electric (CE) Series
Component Removal
3-2
#826496 - Revision A - May, 2015
COMPONENT REMOVAL
This section explains how to remove components from a Wolf CE Series. Depending on which component you are
going to remove, you may have to remove other components first. Refer to the appropriate section in this manual
that explains how to remove those various components. When reassembling, just reverse the steps that were used
to remove the components.
NOTE:
Before attempting to access or remove any components from a Wolf appliance, take note of the WARN-
INGS and CAUTIONS below.
•
TO AVOID ELECTRIC SHOCK, POWER TO THE UNIT MUST BE DISCONNECTED WHENEVER SERVICING
AND/OR ACCESSING COMPONENTS.
•
KEEP IN MIND THAT COOKTOP SURFACES AND COMPONENTS GET HOT DURING USE OF THE APPLI-
ANCE.
•
PULLING A UNIT FROM ITS INSTALLATION SHOULD ONLY BE PERFORMED BY A CERTIFIED SERVICE
TECHNICIAN OR INSTALLER.
•
When working on the cooktop and components, be careful when handling sheet metal parts. They may
have sharp edges.
Tools Needed
6-Lobe Torx type driver size T-15
•
1/4” nut driver or socket
•
11/32” nut driver or socket
•
Phillips screw driver
•
Small Phillips screw driver
•
Small flat blade screw driver
•
Needle nose pliers
•
