Page 20
Cooktop Electric (CE) Series
Cooktop Electric (CE) Series
Troubleshooting
4-2
#826496 - Revision A - May, 2015
TROUBLESHOOTING
This section of the manual contains troubleshooting information which will help the Certified Service Technician trou-
bleshoot a Wolf CE Series. The table of contents below shows how the troubleshooting section is laid out.
ELECTRIC
Power board and control board share the software for controlling the cooktop. If a logic or programing issue is sus-
pected replace the control board first as it is the less expensive part.
Error E6 occurs whenever cooktop is connected to 120 VAC. When using the unit in Showroom mode on 120 VAC,
after the error occurs proceed with the steps to place the cooktop in Showroom mode. The error clears once in
Showroom mode.
•
TO AVOID ELECTRIC SHOCK, POWER TO THE UNIT MUST BE DISCONNECTED WHENEVER SERVICING
AND/OR ACCESSING COMPONENTS.
•
COOKTOP SURFACES AND COMPONENTS GET HOT DURING USE OF THE APPLIANCE.
•
PULLING A UNIT FROM ITS INSTALLATION SHOULD ONLY BE PERFORMED BY AN CERTIFIED SERVICE
TECHNICIAN OR INSTALLER.
•
When working on the cooktop and components, be careful handling sheet metal parts. They may have
sharp edges.
