Page 45
5-17
#7040743 - Revision A - September, 2016
Component Removal
Built-In Wine Storage (BW) Series
Built-In Wine Storage (BW) Series
Compressor
The Compressor is secured to the unit tray with three
shoulder screws that pass down through rubber grom-
mets in the compressor base and into holes in unit tray.
A metal tab formed into the unit tray passes up through
the fourth rubber grommet and the compressor base.
After capturing the refrigerant from the sealed system,
(See Figure 5-38):
1.
Disconnect wire leads from compressor electricals.
2.
Using a tube cutter, cut suction and discharge tubes
approximately 1” from compressor stubs.
3.
Extract compressor mounting shoulder screws, then
lift compressor off of unit tray.
Condenser
Holes in the front and rear bottom flanges of the con-
denser fit over threaded studs in the unit tray, then a
nut is applied to each threaded stud to hold the con-
denser in place.
NOTE:
The condenser inlet and outlet stubs are at the
rear of the condenser.
After capturing the refrigerant from the sealed system,
(See Figure 5-39):
1.
Remove the 3/8” nuts from the threaded studs at
the front and rear of condenser, then lift condenser
slightly to clear threaded studs and pull condenser
forward.
2.
Using a tube cutter, cut condenser inlet and outlet
tubes approximately 1” from condenser stubs, then
remove condenser fully from unit tray.
Figure 5-38. Compressor Removal
Cut Here
Compressor
Shoulder
Screws (3)
Rubber Grommets (4)
Compressor
Electrical
Assembly,
Capacitor & Clip
Figure 5-39. Condenser Removal
Inlet and Outlet
are at back of
Condenser
Condenser