Page 25
7-25
Built-In
Built-In
(600-
(600-
2
2
)
)
Series
Series
Component Access / Removal
#3758407 - Revision B - August, 2006
Ice Bucket (601F-2)
Lift ice bucket up out of freezer basket (not shown).
Freezer Basket Assembly
(601F-2)
To remove freezer basket assembly
1.
Pull basket open until it stops.
2.
Lift up at front and pull out.
Freezer Glass Shelf (601F-2)
The glass shelf is secured to the side walls by screws
that pass through the side frames.
To remove the freezer glass shelf
1.
From underneath glass shelf, remove the two front
mounting screws
2.
Loosen the two rear screws.
NOTE:
The rear screws fit into slots, so they do
not need to be fully removed.
3.
Pull shelf forward slightly and lift up and out.
NOTE:
When reinstalling freezer glass shelf, make sure
flange at top of freezer basket center slide support sets
into the channel in freezer glass shelf front.
Icemaker Assembly (601F-2)
The icemaker assembly is located behind the top right
freezer basket, just below the glass shelf. It is attached
to the drain trough enclosure with two screws at top
and one at bottom.
To remove the icemaker assembly, the top right freezer
basket must first be removed, then
1.
Disconnect ice level mechanism by sliding connect-
ing rod to right, off of icemaker shut-off arm, allow-
ing ice level arm to drop out of the way.
2.
Extract screw at bottom left of icemaker.
3.
Extract screws at top of icemaker.
4.
Pull forward and disconnect electrical leads.
Figure 7-58. Icemaker
Connecting rod
Icemaker
Figure 7-56. Freezer Basket
Figure 7-57. Freezer Glass Shelf
Rear slots
Flange
