Stuart Turner Showermate 1.5 bar Single, Руководство по установке, Страница: 7 / 21

- 7 -
Do not allow contact with oil or cellulose based paints, paint thinners
or strippers, acid based descalents or aggressive cleaning agents.
The hose connection nuts on the inlet and outlet of the pump should
not be removed.
1. Stuart Turner recommend only the use of their 15 mm flexible hoses.
The hose and pump are fitted with plastic push-in connectors, which must only be
connected with the following:
a)
15 mm diameter copper pipe to BS EN 1057 - R250 (half hard) - Table 3.
b) 15 mm plastic pipe to BS 7291 part 1 and part 2 (Table 1), or part 3 (Table 1)
plus internal support sleeve*.
* The internal bore of the plastic pipe must be supported against collapse with the
pipe manufacturers recommended support sleeve (pipe insert).
c) Appropriate plumbing fittings from the John Guest 'speedfit' push-in plumbing
fitting range.
Other manufacturers fittings are not necessarily compatible and may not provide a
water tight connection.
Ensure the pipe is free from all score marks and deformities in the area of the
insertion depth (Fig. 10) and cut the pipe square removing all burrs and sharp edges
to prevent damage to the sealing 'O'-ring.
2. Prior to inserting pipe into fitting, mark the insert depth on the wall of the pipe with a
soft pencil at a distance of 30 mm from the end to be inserted (Fig. 10).
Cont....
15 mm Pipe
Pencil Mark
Insert Depth
30 mm
Fig. 10