Stryker Medical Renaissance Series, Руководство по обслуживанию

Страница: 16 / 123

Service Information
15
BASE HOOD REMOVAL AND REINSTALLATION
Required Tools:
Phillips Head Screwdriver 5/32” Ball Driver Bungee Cords or String
Procedure:
1. Raise bed to full up and unplug power cord from wall receptacle.
2. Remove four Phillips head screws holding hood to base assembly and separate Velcro that secures hood
to base tubes.
3. Secure hood to litter using bungee cords, string, etc. so that bed servicing can be easily performed.
4. If more room is needed for service, bellows can be raised above plastic bellows cap. For maximum ac-
cess, disconnect bellows cover switch from its cable. Using a 5/32” Ball driver, remove two Allen bolts
holding bellows cap to jack and remove bellows cap and bellows cover switch.
5. To reinstall hood after bed service has been completed, remove whatever was used in step 3 to secure
hood to litter and place hood back in correct position on base assembly.
6. Reinstall four Phillips head screws that hold hood to base assembly and press down on hood to secure
Velcro holding hood to base tubes.
7. If bellows cover switch was removed, place switch back into bellows cap and reconnect cables. Put bel-
lows and bellows cap onto jack cylinder. Be sure to install caps into ”cutout” groove in jack cylinder. Rein-
stall Allen bolts removed in step four and tighten.
CAUTION
If bellows caps are not installed in the proper location, damage to the caps and switch could occur, or insuffi-
cient activation of the switch may result.
8. Put first pleat at top of bellows around bellows cap and tuck bottom of bellows into base hood.