Discotom-50
Mode d'emploi
Brancher l’unité de recyclage (optionnelle), code TRECA comme
suit:
Brancher l'unité de recyclage
(optionnelle)
Pour brancher le câble électrique pour la pompe de recyclage,
retirer la plaque arrière supérieure sur Discotom-50 et suivre
les instructions dans le schéma de câblage qui se trouve à
l’intérieur de la plaque arrière.
Une fois branchée, vérifier que la pompe tourne dans la
direction indiquée par une flèche au-dessus de la pompe. Si la
pompe ne démarre pas, intervertir deux des phases au moteur
de la pompe et revérifier.
Remplacer la plaque arrière.
Serrer le tuyau d’arrivée de la pompe et brancher l’autre
extrémité à l’arrivée d’eau sur Discotom-50
i
.
Brancher le tuyau de connexion à la sortie d’eau
k
, monter le
tuyau d’écoulement de grande dimension et le fixer à l’aide du
collier de serrage de large dimension.
Placer le réservoir sur le chariot.
Placer un sac plastique jetable (EXOSP) dans le réservoir en le
repliant sur le bord.
Remplir le réservoir de 63 l d’eau additionnée de 2 l d’additif
Struers d’eau. Le niveau d’eau doit se trouver à environ 8 à 10
cm au-dessous du bord supérieur du réservoir.
Adapter le couvercle et le tamis du réservoir.
Remettre le réservoir à sa place et guider la sortie d’eau et
l’écoulement de trop-plein
k
et
h
vers le réservoir d’eau de
refroidissement. Si nécessaire, ajuster les longueurs.
IMPORTANT
c
Un niveau trop élevé de liquide de refroidissement dans le réservoir peut
endommager la pompe. Pour éviter cela, placer le sac jetable de façon à ce
que l'orifice prédécoupé se trouve en face du trou de trop-plein dans le
réservoir.
d
Toujours maintenir correcte la concentration d'additif Struers dans l'eau
de refroidissement (pourcentage indiqué sur la bouteille d'additif). Se
rappeler d'ajouter l'additif Struers à chaque remplissage d'eau.
Si la pompe de recyclage est surchargée ou bloquée, un coupe-
circuit thermique va déconnecter la pompe. Ce coupe-circuit de
sécurité doit être réenclenché en appuyant sur le bouton rouge au
dos de Discotom-50
d
avant que la machine puisse être remise en
marche.
Bouton de mise à zéro
6
Содержание Discotom-50
