Struers Accutom-50, Руководство пользователя

Страница: 25 / 226

Accutom-50
Instruction Manual
21
Accutom-50 can be programmed to automatically cut several slices
from the same sample. Pressing F1 toggles between SINGLE CUT
and MULTIPLE CUT.
The normal cutting operation, where only one single cut is carried
out.
A series of cuts is carried out.
If Multiple Cut has been selected, the desired number of slices to be
cut from the sample can be set.
The thickness of the slices to be cut is defined.
After start is pressed, Accutom-50 will perform one straight cut to
have a reference surface.
Then the sample is retracted and moved to the left in the X-direction,
according to the set thickness of the slice.
The thickness of the cut-off wheel will automatically be compensated
for.
Then the next cut will be performed and the above will be repeated
until the defined number of slices has been obtained.
Note! The defined number of slices includes the reference slice.
If the programmed number and thickness of slices exceeds the
possible number of slices, Accutom-50 will automatically tell you how
many slices can be obtained.
The nominal thickness values for all Struers cut-off wheels are
already saved within the wheel definitions. Whenever a cut-off wheel
is selected, that particular wheel-thickness will automatically be used.
For user defined wheels though, the thickness has to be entered
manually when configuring the wheels in the configuration menu.
Accutom-50 automatically compensates for the thickness of the cut-
off wheel when multiple cut is used. However, due to differences in
feed speed and wheel speed between different methods where the
same wheel is used, additional compensation might be necessary:

After cutting a few test slices, the obtained thickness is
measured, and the deviation from the pre-set thickness has to be
entered as drift correction value, delta(
δ
).
Cutting Mode
Single Cut
Multiple Cut
Slices
Thickness
Drift Correction Value (
δ
):