Strobel VEB100-6 2, Инструкции механика

Страница: 33 / 50

29
MA_VEB100-6_A2_200716_en.doc
3.11.2 Tape guide (Fig. 14)
At works the tape guide is set to a standard tape width of 15 mm.
However, tape guide (7) can be set to tape widths from 15 to 25 mm.
But depending on the required tape width different blowing nozzles have to be used
and are available as optional extras.
Setting the tape width of the tape guide:
-
Set the tape guide to the required width.
-
Tape guide (7) is infinitely adjustable by turning threaded spindle (8).
turning to the left

larger tape width
turning to the right

smaller tape width
-
The distance between tape guide and tape should be 1 mm minimum.
-
Replacing the blowing nozzle:
-
Loosen and remove screw (9).
-
Replace the blowing channel.
-
Screw-on and tighten screw (9).
3.11.3 Tape feed (Fig. 14)
Driving roll (10) is pressed towards the tape by means of part (11) and is driven by
electric motor (12). By means of the tape blowing device the tape is blown under the
stitch plate.
The fed tape length should always be long enough to allow the feed dog to catch the
tape for sewing.
The delaying time and the switch-on time of the tape feed can be altered (that is, the
given tape length) (see sewing drive instruction).
3.11.4 Tape blowing device (Fig. 14)
During the tape feed process the air nozzle in the blowing channel blows the tape
under the stitch plate.
The delaying times of the tape blowing-in device can be altered (see sewing drive
instructions).
Also the air quantity can be regulated by means of a throttle.