34
●
Connect the red clamp to the positive terminal
(+) of the vehicle’s battery and the black clamp
to the negative one (-).
●
Be sure to adjust your clamp for maximum
contact for both sides of the clamp. Always
check if the clamps are well connected.
●
When using the clamps, do not allow the
positive and negative poles to contact each
other. This may cause sparking and result in a
safety hazard and cause a short circuit of the
Jump Starter.
●
Turn on the jump starter. Put the vehicle key
back into the ignition and start the car.
●
If the auto cannot be started, you need to
disconnect the jumper cables from the Jump
Starter and the vehicle.
Wait for at least 1
minute
, and then repeat the steps above..
●
When the vehicle is started, first turn off the
jumpstarter. Remove the jumper cables from
the Jump Starter and then remove the red and
black clamps from the vehicle battery.
●
Leave the vehicle’s engine running for a while.
●
After jump-starting a vehicle, it is
recommended to recharge the Jump Starter
before reuse.
③
④
⑤
