8
Start up
Remove machine from packing, fill-up the internal water tank and
connect the machine to an appropriate power outlet through the
power supply cable.
Please perform installation procedure in accordance with the local
country’s safety regulations. A correct start-up procedure can be
performed by following the steps listed here below.
1. Remove the cup-tray or slide it forward, by holding the frame,
until the top opening of the internal water tank is accessible.
2. Pour 3 litres (approx) of filtered drinking water (*) into the
water tank.
3. Put cup-tray back to its original position.
4. Put main switch in ON position and verify the built-in pilot light
is on, thus indicating machine electrical circuits are powered.
5. Wait until the boiler pressure gauge indicates 1.2 bar (approx. after
15 min.). When above pressure is reached, the machine is ready
for use.
6. Open steam valve for a few second and then close it again.
7. Make sure working pressure reaches the rated value before
preparing coffees.
Important Notice
All refill and cleaning procedures must be carried-out with machine disconnected from
power source. The Manufacturer accepts no liability for injury and to persons or property
caused by incorrect installation and/or use of the machine.
