Strautmann Sherpa 120, Руководство по эксплуатации, Страница: 133 / 209

Service and maintenance
Sherpa 120, 140 | 06.19 133
•
Use appropriate equipment and gloves when replacing
working tools with blades.
•
After the diesel engine has been switched off, wait four
minutes to ensure that the AdBlue
® lines have been
evacuated and the engine control has shut down. Switch
off the battery disconnector only then.
•
Switch the battery disconnector off and disconnect all
electrical/electronic plug-in connections before carrying
out electrical welding work on the machine.
•
Protect adjacent parts when carrying out welding, drilling
and grinding work and when working with cut-off wheels.
This applies in particular to power, hydraulic, brake and
supply lines.
– Cover the lines or remove them at especially critical
spots.
•
Dispose of oils, greases and filters properly.
•
Check all hose pipes with special care for visible defects.
•
Observe environmental protection measures when
carrying out service and maintenance work on the
machine.
•
Observe applicable local regulations regarding the
disposal. This applies also to parts having come into
contact with operating media.
•
Properly handle and dispose of substances and materials
used for cleaning the machine. This applies in particular
when working on lubrication systems and devices and
when carrying out cleaning work using solvents.
•
Load-bearing parts may break due to mechanical work
on frame elements. Risk of material damage and serious
injuries or even death.
As a basic principle, the following is not allowed:
– Drilling at the frame or chassis.
– Boring-up of existing holes at the frame or chassis.
– Welding on load-bearing parts.
•
Exclusively use original spare parts or parts approved by
the manufacturer.
•
After finishing maintenance work, check the safety and
protective devices for proper functioning.
– Immediately replace missing or defective protective
devices.