Operation
Sherpa 120, 140 | 06.19
107
7. Move and keep hold of the joystick to the left (2) with the
enabling button (1) pressed:
→ The cutting knives work, conveyor drum and elevator
conveyor start to run in the conveying direction.
8. Release the enabling button (1) and keep hold of the
joystick to the left (2).
9. Move the joystick to the front (3):
→ The pick-up arm lowers, while the silage is cut out of the
silo stack and conveyed into the mixing container.
Fig. 79
10. Lower the drive speed of the elevator conveyor by means
of the manual throttle lever if necessary, e.g. if silage is
thrown over the mixing container.
11. Observe the pressure indicator (1) of the conveyor drum
during picking-up and adapt the picking-up speed such
that the value does not exceed 190 bar.
12. Reverse conveyor drum and elevator conveyor if
necessary, e.g. if
–
the conveyor drum is clogged due to overload and
the warning lamp (1) lights up.
–
too much silage has been picked up which should
not be conveyed into the mixing container.
Fig. 80
Reverse
13. Keep hold of the joystick to the right (2) with the enabling
button (1) pressed.
→ Elevator conveyor and conveyor drum run in the reverse
direction. The silage is thrown out to the front.
Finish picking-up
14. Release the joystick such that it returns to its neutral
position.
→ Cutting knives, conveyor drum and elevator conveyor
stop.
Fig. 81
15. Enable and press the key "Cutting knives" (1).
→ The cutting knives are disabled.
Fig. 82
Содержание Sherpa 120
Страница 2: ......
