Stratasys Dimension BST 1200, Руководство пользователя

Страница: 18 / 68

18 Setup
Dimension BST 1200 / SST 1200 User Guide
Installing Forklift Access Covers
The forklift access covers can be placed over the forklift channels
after the printer is placed in its final location (see
Figure 4 ). The
covers are press-fit in the front and held in place with one screw in
the rear.
Figure 4: Installing the forklift access covers
Power Connections
This section discusses the procedure for preparing all power
connections for the printer.
Dimension is provided with two power cords: one for 110 V and one
for 220 V.
Prepare all power connections:
1. Connect the male end of the supplied power cord directly into a
grounded electrical outlet, as shown in Figure 5 on page 19 . (If
using a Uninterrupted Power Supply (UPS), connect the cord
directly into the UPS).
CAUTION
Before connecting power to the printer,
make sure that the Dimension circuit
breaker is in the off (down) position. It is
located in the rear of the printer next to
the power cord attachment point.
Insert Tab in Slot
Push Cover Toward Front
of Printer
Attachment Screw
on Back of Printer