Stratasys Dimension BST 1200, Руководство пользователя

Страница: 36 / 68

36 Operation
Dimension BST 1200 / SST 1200 User Guide
Unload material cartridges:
1. From
Idle
(or
Ready To Build
), Press
Material Load
.
A. The panel displays
Load Material
and prompts with,
Replace model ?
• Press
Yes
. to unload the Model Material.
The panel displays
Replacing model
,
• Press
No
if you do not wish to unload the model
material.
B. The panel then prompts with,
Replace support?
• Press
Yes
. to unload the Support Material.
The panel displays
Replacing support
,
• Press
No
if you do not wish to unload the support
material.
C. After you have made the above choices, the panel displays
Unloading
for approximately 2 minutes (the selected
materials will be unloaded from the extrusion head).
D. When unloading is complete, the panel will prompt you to
remove a cartridge based upon your choices - i.e.,
Remove Both Cartridges, Remove Model (Top)
Cartridge,
or
Remove Support (Bottom)
Cartridge
.
2. Remove the material cartridge(s) by first pushing it forward
gently, and then pulling it out of the slot.
• When you remove a cartridge there will be approximately
213 cm (7 feet) of filament that will need to be pulled from
the system. (This is normal. Material is only retracted from
the extrusion head during ‘unloading’.)
3. To store a partially used cartridge, place a small flag of tape on
the filament near the cartridge. Cut off and discard the
remaining material. The tape flag ensures the filament does
not retract into the cartridge.
CAUTION
Do NOT try to rewind the filament that
remains in the system. This will cause
material to cross-wind in the cartridge
causing cartridge failure.